Do you know the steps to decorate and paint?

When decorating, painting is very important. If you want to paint, what are the good steps for everyone to understand? Custom Pattern Roller Leading Supplier will introduce the methods in this area today so that everyone can have a better painting step and bring good results.

Decoration brush painting steps:

Primary treatment of wall painting process

Remove the peeling and lose parts of the wall, and makeup with cement mortar. If there are cracks, use kraft paper tape and white latex to stick the cracks. Generally, non-load-bearing walls, such as light-weight walls and thermal insulation walls, need to be covered with cloth. Try to choose a better-quality wall cloth and white latex or grid cloth. The grid cloth will have a better crack prevention effect.

Brush interface agent for the wall painting process

The interface agent can enhance the adhesion to the base layer, avoid the phenomenon of emptying and shelling of the plaster layer, and thus replace the manual chiseling process, saving time and effort. When brushing the interface agent, be sure to use Soft Pattern Roller to brush evenly.

Soft Pattern Roller

Soft Pattern Roller

Wall leveling for the wall painting process

The uneven wall surface needs to be leveled, and the uneven surface should be leveled with stucco plaster, so that the error of the wall surface does not exceed 3 mm. If the yin and yang angles are not straight, you also need to paint the plaster and use a ruler to straighten it.

Batch scraping putty for the wall painting process

It is better to use putty with higher particle fineness and harder texture. Putty should be approved three times. The first pass is generally thicker because it involves leveling. The second and third passes are thinner, mainly for light collection, to make the wall look smoother and flatter. After three batches, the thickness of the putty must not exceed 3mm, otherwise, it will easily crack.

Polishing of wall painting process

Sanding is a key step in the painter's process. After sanding is completed, the effect of painting can be good. Try to use thinner sandpaper, if the sandpaper is too thick, it will leave deep sand marks. Be sure to clean the wall thoroughly after sanding to avoid too much dust and affect the adhesion of the paint. The unevenness does not exceed 3 mm.

Primer for wall painting process

The primer must be brushed evenly to ensure that it is brushed everywhere. If the wall has a large amount of paint, it is best to add a little more water to the primer. To ensure that it can be applied evenly, you can also choose our 7 Inch Pattern Roller.

Repair of the wall painting process

After the putty is polished, there will be some flaws, which are difficult to see under normal circumstances. It will be obvious only after brushing the paint once. At this time, it needs to be repaired. Note that you must polish and smooth the patch, and then brush it with a little more water primer, so as to avoid the color difference when the topcoat is different from the draught of other walls.

The above are the steps that introduced to decorate the wall for you. You can use it as a reference to understand, so you need to buy good paint and carry out the painting work correctly, I believe it will definitely bring very good results.

hot Products